Author Topic: SOLVED - How to display adoptive parents in Dynamic Tree view  (Read 356 times)

0 Members and 1 Guest are viewing this topic.

Offline DarWhi

  • VIP
  • Newbie
  • *
  • Posts: 2
    • View Profile
I have my grandmothers GEDCOM entries listing her both her birth and adoptive parents. Birth parents are a FAMC entry with PEDI birth and Adoptive parents are a FAMC with PEDI adopted.

If I search the birth parents I can bring up their information in the CYGNUS editors, then add other children etc. from there. If I open my grandmother in the ARIES editor,  I can correctly see both sets of parents. So I know they are properly connected to her.

My problems is I cannot figure out how to display the birth parents in the Dynamic Tree view. I can only see the adoptive parents.

However, this is an important tree to follow back, and it would be so much easier if I could use the Dynamic Tree to help make sense of it all.

Screenshots show one GEDCOM window version with ADOP property and one without. I was checking to see if that might make a difference. It did not.

In summary, I have a person (grandmother) with birth and adopted parents, and I cannot get birth parents to show in the Dynamic Tree.

« Last Edit: February 15, 2023, 19:58:09 by DarWhi »

Offline Zurga

  • VIP
  • Supernatural Member
  • *
  • Posts: 3 475
    • View Profile
Re: How to display adoptive parents in Dynamic Tree view
« Reply #1 on: February 15, 2023, 19:53:51 »
The two images seem the same to me.
I have tried : change the order of the FAMC tag in GEDCOM editor, you should be able to display one or the other family.

Zurga

Offline DarWhi

  • VIP
  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: How to display adoptive parents in Dynamic Tree view
« Reply #2 on: February 15, 2023, 19:57:27 »
That worked!!!

Thank you so much Zurga. I never would have tried that.

Darrin