Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DarWhi

Pages: [1]
1
ENGLISH / Re: How to display adoptive parents in Dynamic Tree view
« on: February 15, 2023, 19:57:27 »
That worked!!!

Thank you so much Zurga. I never would have tried that.

Darrin

2
I have my grandmothers GEDCOM entries listing her both her birth and adoptive parents. Birth parents are a FAMC entry with PEDI birth and Adoptive parents are a FAMC with PEDI adopted.

If I search the birth parents I can bring up their information in the CYGNUS editors, then add other children etc. from there. If I open my grandmother in the ARIES editor,  I can correctly see both sets of parents. So I know they are properly connected to her.

My problems is I cannot figure out how to display the birth parents in the Dynamic Tree view. I can only see the adoptive parents.

However, this is an important tree to follow back, and it would be so much easier if I could use the Dynamic Tree to help make sense of it all.

Screenshots show one GEDCOM window version with ADOP property and one without. I was checking to see if that might make a difference. It did not.

In summary, I have a person (grandmother) with birth and adopted parents, and I cannot get birth parents to show in the Dynamic Tree.


Pages: [1]