Ancestris - Forum

Ancestris Support => ENGLISH => Topic started by: DarWhi on February 15, 2023, 14:57:41

Title: SOLVED - How to display adoptive parents in Dynamic Tree view
Post by: DarWhi on February 15, 2023, 14:57:41
I have my grandmothers GEDCOM entries listing her both her birth and adoptive parents. Birth parents are a FAMC entry with PEDI birth and Adoptive parents are a FAMC with PEDI adopted.

If I search the birth parents I can bring up their information in the CYGNUS editors, then add other children etc. from there. If I open my grandmother in the ARIES editor,  I can correctly see both sets of parents. So I know they are properly connected to her.

My problems is I cannot figure out how to display the birth parents in the Dynamic Tree view. I can only see the adoptive parents.

However, this is an important tree to follow back, and it would be so much easier if I could use the Dynamic Tree to help make sense of it all.

Screenshots show one GEDCOM window version with ADOP property and one without. I was checking to see if that might make a difference. It did not.

In summary, I have a person (grandmother) with birth and adopted parents, and I cannot get birth parents to show in the Dynamic Tree.

Title: Re: How to display adoptive parents in Dynamic Tree view
Post by: Zurga on February 15, 2023, 19:53:51
The two images seem the same to me.
I have tried : change the order of the FAMC tag in GEDCOM editor, you should be able to display one or the other family.

Zurga
Title: Re: How to display adoptive parents in Dynamic Tree view
Post by: DarWhi on February 15, 2023, 19:57:27
That worked!!!

Thank you so much Zurga. I never would have tried that.

Darrin